STORET Remark Codes applied to results. Column header "R" in results reports. Code Description ---- ------------------------------------------------------------- A Value reported is the mean of two or more determinations B Results based upon colony counts outside the acceptable range C Calculated. Value stored was not measured directly, but was calculated from other data available D Field measurement. Some parameter codes (e.g., 401 "Field pH") imply this condition without this remark E Extra sample taken in composting process F In the case of species, F indicates Female sex G Value reported is the maximum of two or more determinations H Value based on field kit determination;results may not be accurate I The value reported is less than the practical quantification limit and greater than or equal to the method detection limit J Estimated. Value shown is not a result of analytical measurement K Off-scale low. Actual value not known, but known to be less than value shown L Off-scale high. Actual value not known, but known to be greater than value shown M Presence of material verified, but not quantified. Indicates a positive detection, at a level too low to permit accurate quantification. In the case of temperature or oxygen reduction potential, M =a negative value. In the case of species, M=male sex N Presumptive evidence of presence of material O Sampled for, but analysis lost. Accompanying value is not meaningful for analysis P Too numerous to count Q Sample held beyond normal holding time R Significant rain in the past 48 hours S Laboratory test T Value reported is less than the criteria of detection U Material was analyzed for, but not detected. Value stored is the limit of detection for the process in use. In the case of species, Undetermined sex V Indicates the analyte was detected in both the sample and associated method blank W Value observed is less than the lowest value reportable under remark "T" X Value is quasi vertically-integrated sample Y Laboratory analysis from unpreserved sample. Data may not be accurate Z Too many colonies were present to count (TNTC), the numeric value represents the filtration volume $ Calculated by retrieval software. Numerical value was neither measured nor reported to the database, but was calculated from other data available during generation of the retrieval report